Attract-Mode Support Forum

Attract-Mode Support => General => Topic started by: johnny5126 on August 17, 2017, 05:57:11 PM

Title: Retroarch
Post by: johnny5126 on August 17, 2017, 05:57:11 PM

I got Retroarch working fullscreen and pretty well with the 188 Mame core.  Problem is, I have no idea how to get the shaders loaded.  Any ideas?

Title: Re: Retroarch
Post by: mc2programmer on August 19, 2017, 12:07:36 AM

not really a question for attract-mode... but here goes when  you launch your game hit f1 then go to the very first option quick menu scroll down to shaders and set to your hearts content...

Title: Re: Retroarch
Post by: johnny5126 on August 19, 2017, 07:17:50 PM

Thanks but is there any way to declare it in the argument area in Attract?

Title: Re: Retroarch
Post by: akafox on August 19, 2017, 09:03:47 PM

1. From the core you are using..I am assuming you are on a PC.
2. mc2programmer is correct this is a retroarch "problem" it has nothing to do with attract mode.
3. Following mc2programmer advice then save configuration for the game..

I believe that will make a config file for the game and load the shader(s) on game launch. However again this needs to be asked on the retroarch forums if you need more help.

Title: Re: Retroarch
Post by: mc2programmer on September 03, 2017, 10:51:37 PM

it might be possible to set shader information from command line.... if you can then in Attract-Modes emulation folder edit the emulation.cfg file and add the required shader parameters... not sure if this can be done. When I have some time I will look into retroarch documentation a bit more to see if you can set shaders via command line.