Attract-Mode Support Forum
Attract-Mode Support => General => Topic started by: therui on June 21, 2019, 06:20:48 AM
-
hi guys
after updating atrract mode via retropie
i get this message
/opt/retropie/configs/all/autostart.sh: line 2: 534 segmentation fault
i tried atrract in the command line
but it gives me segmentation fault message
heres my autostart.sh
attract #auto
my ES-Start.sh
emulationstation #auto
and my AM-Start.sh
# Original
# emulationstation #auto
# stty -echo;attract &> /dev/null; stty echo
# attract > /dev/null 2>&1
attract
i did no modify a thing just updated and got the error
hope someone can help me out
thank you guys
-
Your update was unsuccessful. If you can't run "attract" from the command line then Attract-Mode is broke and it has nothing to do with your autostart.sh file. Your autostart.sh just can't run "attract" because it's broke.
Read the Pi FAQ http://forum.attractmode.org/index.php?topic=1249.msg9046#msg9046 (http://forum.attractmode.org/index.php?topic=1249.msg9046#msg9046) step 1 and its warning. If you upgrade differently than you originally installed you might have an issue, otherwise perform the update again to fix your broken AM (and take note of any errors or issues). If you still have issues please provide details about your pre-update setup (i.e. how you originally installed AM, versions, ffmpeg installed or not, firmware, etc).
-
thanks progets
i will give it another shot
-
I am confused. Your seg-fault is on a file which is not the ones you posted. Are you sure you pinpointed it correctly? Try actually launching attract from the terminal and not through scripts.
-
Hi
Simply like typing attract in the terminal?
I am not sure I know how to do that