1
General / AM System Configuration Utility
« on: March 16, 2020, 01:08:35 PM »
Hi All
Please can you assist. I am running a Raspberry PI 3b+ with a 128gb Sandisk SD Card. I loaded the Wolfanoz Arcade only 32gb image. Whenever I boot up I get the below error.
"run AM System COnfiguration Utility to reset the attract.cfg file with a proper identifier"
I do get into attract mode and all works fine. However I would like to get rid of this error.
Is there somthing I need to change or look at to remedy this.
Please can you assist. I am running a Raspberry PI 3b+ with a 128gb Sandisk SD Card. I loaded the Wolfanoz Arcade only 32gb image. Whenever I boot up I get the below error.
"run AM System COnfiguration Utility to reset the attract.cfg file with a proper identifier"
I do get into attract mode and all works fine. However I would like to get rid of this error.
Is there somthing I need to change or look at to remedy this.