Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Chillimonster

Pages: [1]
1
General / Re: Raspberry Pi Image for Pi 2 and Pi 3
« on: September 07, 2016, 03:06:12 AM »

Please , I have problems with this update . the previous all my arcade controls worked ok .. for the new one does not accept the command down during navigation Attract . to add the command "down" it appears " UPOS " and exit the setting the " UPOS " turns into "up" , even though I have already set up the command " up" .




I had a similar issue due to a bug in the latest version. (I have a thread about it on here).

I guess you are using Zero Delay (Dragonrise) encoders?

You can get round it in two ways - the first is to manually compile V4 onto a Retropie 4.0 installation, and the other would be to use the pre-built 4.0 image and update retropie via the retropie setup script.


2
Would that not download and install the latest version of AM (2.1)?

That will not work with my usb encoders hnce the question of installing an 'older' version (2.0)


3
Anyone any idea?

I really dont want to have to start from scratch :-(

4
Morning.

I have a retropie 4.0 image that is just how i like it and want to play with Attract mode on the same image

The latest 4.0 image from Floob will not work correctly as there is a bug in the Atttract Mode stopping my dragonrise usb encoders from working properly so would need to install the 2.0 version of Attract mode.

How would i do this?

Hopefully its quite simple :-)

Thanks

Chilli

5
General / Re: Raspberry Pi 3 Image
« on: April 14, 2016, 06:24:49 AM »
Loving this, and make the Pi feel fresh.

Getting my head around the configurations and settings, but liking what i see so far.


Pages: [1]