Attract-Mode Support Forum
Related Stuff => Emulators => Topic started by: bionictoothpick on December 26, 2015, 07:39:19 PM
-
The following works from the command line, but not from within Attractmode:
/usr/bin/retroarch -L /usr/lib/x86_64-linux-gnu/libretro/mupen64plus_libretro.so "/home/toothpick/games/n64/test.z64"
I've copied and pasted the text from Attractmode terminal and it will run successfully as well.
Here is the msg: Error executing: retroarch -L /usr/lib/x86_64-linux-gnu/libretro/mupen64plus_libretro.so "/home/toothpick/games/n64test.z64"
If I copy and paste the above it will run the rom as intended.
Thoughts?
-
The following works from the command line, but not from within Attractmode:
So I ran into some similar issues getting retro arch working too.
not sure if this helps, but here is a copy of my AM config. I use system specific configs in retroArch, and load the config as part of the args. The config references the core to load.
HTH.
# Generated by Attract-Mode 1.6.0
#
executable /usr/bin/retroarch
args -c /emu/retroarch/mupen64plus.cfg "[rompath][name][romext]"
rompath /emu/roms/Nintendo 64
romext .n64;.z64;.v64;.7z
-
Thanks.
-
For linux, on the cmd you need this ./file.bin
so, /usr/bin/./retroarch