Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - brat boy

Pages: [1]
1
General / Re: AM System Configuration Utility
« on: March 17, 2020, 10:44:08 AM »
Thanks will give it a try

2
General / Re: error on startup
« on: March 16, 2020, 01:25:52 PM »
Did you get a fix to this, I am getting the same errors you are experiencing, also please advise how you fixed theses "shutdown.py, intro videos missing"

3
General / AM System Configuration Utility
« on: March 16, 2020, 01:08:35 PM »
Hi All

Please can you assist. I am running a Raspberry PI 3b+ with a 128gb Sandisk SD Card. I loaded the Wolfanoz Arcade only 32gb image. Whenever I boot up I get the below error.
"run AM System COnfiguration Utility to reset the attract.cfg file with a proper identifier"

I do get into attract mode and all works fine. However I would like to get rid of this error.

Is there somthing I need to change or look at to remedy this.

Pages: [1]