Author Topic: ArcadeBliss - Cab Edition: 2016-05-16 Update  (Read 69303 times)

einarsen

  • Newbie
  • *
  • Posts: 3
    • View Profile
Re: ArcadeBliss - Cab Edition
« Reply #60 on: August 29, 2016, 04:19:49 PM »
This might come off wrong, but I'm digging that mobile cart beside your arcade in the picture. I definitely could use something like that, is it custom made? The arcade is not bad either but I can't take my eyes off that damn cart. LOL...

100% with you. That multiple control panel setup is SWEET!

atrfate

  • Full Member
  • ***
  • Posts: 86
    • View Profile
Re: ArcadeBliss - Cab Edition: 2016-05-16 Update
« Reply #61 on: August 29, 2016, 04:24:55 PM »

This has nothing to do with the Attract Mode theme (which looks cool) but your swappable control panels. I LOVE that idea. I wanted to do that for my Taito cabinet but abandoned the idea when I discovered that I'd have to rewire the coin mechs (I don't use buttons to replicate coin drops, only the real thing). However, seeing your rack of control panels makes me want to revisit the Molex idea where I wire a Ultimarc control board to a female end and then attach a male end to each of the control panels. Either that or do a smaller Molex for the coin mechs and then just mount a dedicated control board to each control panel and then go USB to the PC.

Which method do you use?

While i dont know why you would go with an ipac since its keyboardbased, when most people these days thanks to xpadder use joystick input boards that being said for connecting ALOT of controls like that id recommend one of the following

Make each panel terminate to a jamma harness that then connects to a male end that connects tot the ipac inside
or
Make each panel terminite to a IDE 40pin connector that then connects to a male IDE that inturn is wired to the ipac

Going molex route means you would have upwards of 10 connectors to connect/disconnect and that be a pain in the ass


For me Id go with usb based solution since you can get cheap usb encoders for 10bucks, id have one permanently inside the machine for coin test service then place 1 each per CPO so the only connect/disconnect when changing pannels would be a single usb cord

ArcadeBliss

  • Sr. Member
  • ****
  • Posts: 195
    • View Profile
Re: ArcadeBliss - Cab Edition: 2016-05-16 Update
« Reply #62 on: February 25, 2024, 06:12:27 AM »

This has nothing to do with the Attract Mode theme (which looks cool) but your swappable control panels. I LOVE that idea. I wanted to do that for my Taito cabinet but abandoned the idea when I discovered that I'd have to rewire the coin mechs (I don't use buttons to replicate coin drops, only the real thing). However, seeing your rack of control panels makes me want to revisit the Molex idea where I wire a Ultimarc control board to a female end and then attach a male end to each of the control panels. Either that or do a smaller Molex for the coin mechs and then just mount a dedicated control board to each control panel and then go USB to the PC.

Which method do you use?



Talk about bringing up the dead :). I use an iPac wired to a SCSI 50 pin connector and an OptiPac wired to a 25pin parraliall port connector. I then just connect the control panels as needed with one cable. That cable also connects to my LED Wiz to handie the lit buttons