Attract-Mode Support Forum

Attract-Mode Support => General => Topic started by: justinide on March 08, 2017, 07:59:10 PM

Title: Exiting emulator
Post by: justinide on March 08, 2017, 07:59:10 PM

I recently built a bartop arcade im trying to map 2 buttons to close out the emulator.  It seems i can map for a single button in the Retroarch config which works.

I also saw in attractmode under emulators it has an option for exit key.  When i make it start+select it works but then locks up the entire arcade where i have to power it completely off.

Also im using the dragonrise joypads, and reys 128gb img.

Title: Re: Exiting emulator
Post by: hermine.potter on March 08, 2017, 10:30:58 PM

@justinide
start AM > press TAB > Plug-Ins > ResFix : Enable > Add your emulator system in 'Specific Emulators'

Title: Re: Exiting emulator
Post by: justinide on March 09, 2017, 05:23:56 AM

Ok, i did that now it doesn't do anything?  Then when I try to exit the emulator using the keypad it gives me an error and locks up.

The error is "Could not open playback device 'default: Device or resource busy".

I'm able to exit with other emulators with no problem, its just when I use the CPS1 Capcom

Title: Re: Exiting emulator
Post by: justinide on March 28, 2017, 08:13:40 PM

Still having same problem when closing mupen64 emulator.  It will just freeze the system and have to hard reset.