Attract-Mode Support Forum

Attract-Mode Support => General => Topic started by: djlenscap on March 09, 2017, 07:22:25 PM

Title: Reset to Default
Post by: djlenscap on March 09, 2017, 07:22:25 PM

I bought a pre-loaded SD card to save time. It launches into attract mode but the keyboard doesn't work and "select" on the control doesn't work.  Is there a way to reset default controls or launch into Emulation  Station? I can't select games or get out of attract  mode at this point. 

Title: Re: Reset to Default
Post by: keilmillerjr on March 09, 2017, 07:34:39 PM

I assume your using retropie. If you stick the we card in computer, there should be a config file for attract mode that you can edit. I would probably add keyboard commands, then stick it back in the pi and use the keyboard to navigate the config (tab) ui and map them to your controller.?

Title: Re: Reset to Default
Post by: djlenscap on March 09, 2017, 07:49:57 PM

I tried inserting in computer  and no configuration files... The guy I bought it from is 0 help as well. 

Title: Re: Reset to Default
Post by: progets on March 09, 2017, 09:25:50 PM

Raspberry Pi F.A.Q. #11 http://forum.attractmode.org/index.php?topic=1249.0

Title: Re: Reset to Default
Post by: djlenscap on March 10, 2017, 07:44:20 AM

Im a moron, but how do I pull up the coding on my computer to reset these?? When I insert my SD card in the computer there is only one file for "config" and it is just a txt file with a couple BS sentences in it.  It is not an actual file of code that I can go in an edit. 

Do I need to get another program to read it?