Attract-Mode Support Forum

Attract-Mode Support => General => Topic started by: brat boy on March 16, 2020, 01:08:35 PM

Title: AM System Configuration Utility
Post by: brat boy on March 16, 2020, 01:08:35 PM

Hi All

Please can you assist. I am running a Raspberry PI 3b+ with a 128gb Sandisk SD Card. I loaded the Wolfanoz Arcade only 32gb image. Whenever I boot up I get the below error.
"run AM System COnfiguration Utility to reset the attract.cfg file with a proper identifier"

I do get into attract mode and all works fine. However I would like to get rid of this error.

Is there somthing I need to change or look at to remedy this.

Title: Re: AM System Configuration Utility
Post by: keilmillerjr on March 16, 2020, 09:13:52 PM

No idea what all these images are.

Try removing attract.cfg. To learn linux command line, if need be, see my wiki as a starting point.

Title: Re: AM System Configuration Utility
Post by: brat boy on March 17, 2020, 10:44:08 AM

Thanks will give it a try