1
General / Re: Noob Question - Controller set up for Hotrod SE
« on: August 18, 2016, 11:09:34 AM »
Thanks. I'll give it a shot.
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
2
General / Noob Question - Controller set up for Hotrod SE
« on: August 18, 2016, 04:54:07 AM »
OK, I'm just getting back into MAME. I built a cabinet about 12 years ago and am setting it back up with a new computer. A lot has changed since the last time I did this so I'm looking for some help. The cabinet uses a hanaho hotrod se controller and I can't figure out how to get attract mode (or mame at all) to use the buttons and joysticks without a lot of manual mapping. I did find a config file with the mappings but am not sure where to put it or how to import it.
Any help would be great. I'm using lubuntu linux and have installed mame. I'm certainly no linux noob but can't figure this one out.
Thank you.
Any help would be great. I'm using lubuntu linux and have installed mame. I'm certainly no linux noob but can't figure this one out.
Thank you.
Pages: [1]