1
General / Re: Change Game Controller?
« on: December 02, 2016, 04:43:12 AM »
For some reason, I’m struggling to get game controllers to work in Attract Mode that work in Retropie 4.1.
I built an arcade for my son and used (2) Easy get controllers and joystick / buttons. Everything works fine in Retropie. Last night I used a new RPi and 32gb SD chip with Attract Mode loaded. I went thru the setup of the controller when I started the system (everything went as normal). However, when I then launched Attract Mode, the buttons would not work. The Joystick seemed OK (scrolling thru Attract Mode), but when I opened a game, I could not get “start”, “select”, “A”, “B” or any of the buttons to work.
I then went back to the old SD card & everything works fine in Retropie (no Attract Mode software loaded).
Has anyone else seen this?
I built an arcade for my son and used (2) Easy get controllers and joystick / buttons. Everything works fine in Retropie. Last night I used a new RPi and 32gb SD chip with Attract Mode loaded. I went thru the setup of the controller when I started the system (everything went as normal). However, when I then launched Attract Mode, the buttons would not work. The Joystick seemed OK (scrolling thru Attract Mode), but when I opened a game, I could not get “start”, “select”, “A”, “B” or any of the buttons to work.
I then went back to the old SD card & everything works fine in Retropie (no Attract Mode software loaded).
Has anyone else seen this?