Messages

1

General / Re: Please help to configure the xpad controllers

« on: May 28, 2017, 04:45:19 AM »

Need help guys!

2

General / Please help to configure the xpad controllers

« on: May 18, 2017, 01:31:56 PM »

Hello,

For some reason, I’m struggling to get game controllers to work in Attract Mode that work in Retropie 4.1.

I built an arcade for my son and used (2) Easy get controllers and joystick / buttons.  Everything works fine in Retropie.  Last night I used a new RPi and 32gb SD chip with Attract Mode loaded.  I went thru the setup of the controller when I started the system (everything went as normal).  However, when I then launched Attract Mode, the buttons would not work.  The xpad controllers seemed OK (scrolling thru Attract Mode), but when I opened a game, I could not get “start”, “select”, “A”, “B” or any of the buttons to work.

I then went back to the old SD card & everything works fine in Retropie (no Attract Mode software loaded).

Has anyone else seen this?

This is my port file inside the emulators folder:

# Generated by Attract-Mode v2.0.0
#
executable           “/bin/bash“
args "[romfilename]"
rompath /home/pi/RetroPie/roms/ports
romext .sh;.SH
system Ports
info_source thegamesbd.net         
artwork    flyer           
artwork    marquee         
artwork    snap           
artwork    wheel           
artwork    boxart          /home/pi/RetroPie/roms//boxart
artwork    cartart         /home/pi/RetroPie/roms//cartart
artwork flyer /home/pi/RetroPie/roms/ports/flyer
artwork marquee /home/pi/RetroPie/roms/ports/marquee
artwork snap /home/pi/RetroPie/roms/ports/snap
artwork wheel /home/pi/RetroPie/roms/ports/wheel

I followed all the setting to configure the xpad controllers in emulation station and attract mode and also the same issue

Please Help!!