Messages

1

General / Re: Does AM reset mednafen.cfg ?

« on: June 10, 2019, 12:23:01 AM »

It works!
Thank you

It seems to be a Windows related problem rather than an AM or emu4crt problem

2

General / Re: Attract Mode @ 640x480i

« on: June 09, 2019, 11:10:43 PM »

Maybe this thread from Calamity (CRT Emudriver creator) may be usefull:

http://geedorah.com/eiusdemmodi/forum/viewtopic.php?id=416

I'm using 648x486@60 for Windows desktop and Attract Mode and It works.

3

General / Does AM reset mednafen.cfg ?

« on: June 09, 2019, 10:01:20 AM »

Emu4crt is a fork of mednafen to be used with 15 khz screen.
https://github.com/emu4crt/files

I'm using the last release of emu4crt with Attract Mode 2.5.1 on Windows 7 pro x64.
I'm also using Calamity's driver to output @15 kHz

Emu4crt folder is placed inside my home directory, so I don't have to worry about Windows write-restrictions.
I've manually changed the following parameters in mednafen.cfg:

Code: [Select]

video.fs 1

video.resolution_switch super
When I run emu4crt from command line, everything works as It's supposed to.
Even if I exit and re-launch the .exe hundred times, the updated mednafen.cfg is stored without any changes.


If I run emu4crt from Attract Mode, only at the first launch full screen and super resolutions works.
This happens because mednafen.cfg is correctly read.

When I exit from Attract Mode to Windows desktop, the following mednafen.cfg lines are lost:

Code: [Select]

;Enable time synchronization(waiting) for frame blitting.
video.blit_timesync 1

;Deinterlacer to use for interlaced video.
video.deinterlacer weave

;Attempt to disable desktop composition.
video.disable_composition 1

;Video output driver.
video.driver default

;Enable frameskip during emulation rendering.
video.frameskip 1

;Enable fullscreen mode.
video.fs 1

;Display to use with fullscreen mode.
video.fs.display -1

;Attempt to synchronize OpenGL page flips to vertical retrace period.
video.glvsync 1

;Video resolution switch (0, native or super).
video.resolution_switch super
If I don't manually add them, Attract Mode launches emu4crt with a default mednafen.cfg that doesn't include the lines shown above.

Any ideas ?

Thank You in advance!

I've posted the same issue on http://forum.arcadecontrols.com where the official emu4crt thread resides.