Attract-Mode Support > General

Setting up artwork in Attract Mode step-by-step

<< < (2/4) > >>

epicrean:
I got the movies from emumovies, where would you suggest getting videos?

progets:

--- Quote from: epicrean on December 29, 2016, 12:02:48 PM ---I got the movies from emumovies, where would you suggest getting videos?

--- End quote ---

Emumovies has both higher quality and lower quality videos. You can try downloading the lower quality videos. You can also try the videos from http://www.progettosnaps.net/videosnaps/. At the end of the day these are really just work arounds. You would be better off upgrading AttractMode to use hardware decoding which would resolve the problem. It will also provide better performance and be easier than replacing all your videos.

epicrean:
I have the newest version of attract mode, so I am not 100% sure what you mean there.  In your previous post you suggested  that I enable hardware (mmal) decoding on the pi.    Can you further explain these options?

I am using a raspberry Pi 3
Latest build of retro pie (updated 4 days ago)
Latest build of Attract Mode (updated 4 days ago)

Thanks in advance

progets:

--- Quote from: epicrean on December 30, 2016, 11:12:45 AM ---I have the newest version of attract mode, so I am not 100% sure what you mean there.  In your previous post you suggested  that I enable hardware (mmal) decoding on the pi.    Can you further explain these options?

I am using a raspberry Pi 3
Latest build of retro pie (updated 4 days ago)
Latest build of Attract Mode (updated 4 days ago)

Thanks in advance

--- End quote ---

Go to Configure-->General-->Video Decoder = mmal. If you don't have this option then you haven't installed ffmpeg to enable hardware decoding.

If you installed AttractMode from the RetroPie experimental menu you need to install ffmpeg as described here https://github.com/mickelson/attract/wiki/Compiling-on-the-Raspberry-Pi-%28Raspbian-Jessie%29 (Method 2). Once you have done that you need to reinstall AttractMode from the RetroPie experimental menu.

If you installed AttractMode from the command line then install ffmpeg as described here https://github.com/mickelson/attract/wiki/Compiling-on-the-Raspberry-Pi-%28Raspbian-Jessie%29 (Method 2) and then follow the steps in the AttractMode build section of the link.

epicrean:
When you say go to configure, where is this suppose to be?

Navigation

[0] Message Index

[#] Next page

[*] Previous page