Author Topic: AM System Configuration Utility  (Read 121 times)

brat boy

  • Newbie
  • *
  • Posts: 3
    • View Profile
AM System Configuration Utility
« on: March 16, 2020, 01:08:35 PM »
Hi All

Please can you assist. I am running a Raspberry PI 3b+ with a 128gb Sandisk SD Card. I loaded the Wolfanoz Arcade only 32gb image. Whenever I boot up I get the below error.
"run AM System COnfiguration Utility to reset the attract.cfg file with a proper identifier"

I do get into attract mode and all works fine. However I would like to get rid of this error.

Is there somthing I need to change or look at to remedy this.
« Last Edit: March 16, 2020, 01:11:47 PM by brat boy »

keilmillerjr

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 1077
    • View Profile
Re: AM System Configuration Utility
« Reply #1 on: March 16, 2020, 09:13:52 PM »
No idea what all these images are.

Try removing attract.cfg. To learn linux command line, if need be, see my wiki as a starting point.

brat boy

  • Newbie
  • *
  • Posts: 3
    • View Profile
Re: AM System Configuration Utility
« Reply #2 on: March 17, 2020, 10:44:08 AM »
Thanks will give it a try